Inside The Made To Order Process For A Handcrafted Helmet

ECE 22.06 is the current European standard that motorcycle helmets are tested against, and it replaced the older ECE 22.05 standard with a wider and more demanding set of tests. Helmets are checked for impact absorption at multiple points on the shell, not just the crown, and the standard also tests rotational forces, which earlier standards largely ignored.

This is slower than fully automated manufacturing, and that is the point. A handcrafted shell trades speed for a level of finish and individual attention that a purely machine made helmet does not offer.

A made to order helmet starts long before any material is cut. Measurements are taken, the intended use of the helmet is discussed, and a rider works with the maker to settle on a shell, lining and finish that suit them specifically, rather than picking from fixed stock sizes.

For a full sizing guide across our range, visit Hedon.com.

To find out more about the made to order process, visit Hedon.com.

Sun and heat are the two things to watch for. Leaving a helmet on a dashboard or in direct sun for long periods will dull and eventually crack leather trim, so a helmet bag or a shaded spot makes a real difference over the life of the helmet.