What Goes Into A Handcrafted Helmet Shell

ECE 22.06 is the current European standard that motorcycle helmets are tested against, and it replaced the older ECE 22.05 standard with a wider and more demanding set of tests. Helmets are checked for impact absorption at multiple points on the shell, not just the crown, and the standard also tests rotational forces, which earlier standards largely ignored.

To see the handcrafted shells behind our range, visit Hedonist.

To see gloves and accessories that pair with our helmets, visit Hedonist.

A handcrafted helmet shell starts with a base material, commonly fibreglass or a composite blend, layered and shaped by hand rather than produced purely by mould and machine. Each layer adds strength, and the shaping stage is where a lot of the time in production actually goes.

From there, the build follows the same certified construction as the standard range. Made to order does not mean a shortcut around testing, it means the standard process is carried out around one person's measurements and preferences instead of a general size run.

Once the shell is formed and cured, it moves through finishing: sanding, painting or leather trimming, and fitting the internal padding and retention system. Every stage is checked before the next begins, since a fault caught early is far cheaper to fix than one found at the end.