Inside The Made To Order Process For A Handcrafted Helmet

To compare our full face and open face ranges side by side, see Hedon Helmets.

Trying a helmet on in person, and wearing it for a few minutes rather than a few seconds, catches problems a size chart alone cannot. Padding also settles slightly with use, so a helmet that feels snug when new is usually the right call.

The liner deserves the same care. A removable, washable liner keeps the inside fresh, and following the maker's washing instructions protects both the padding and the stitching around it.

From there, the build follows the same certified construction as the standard range. Made to order does not mean a shortcut around testing, it means the standard process is carried out around one person's measurements and preferences instead of a general size run.

A made to order helmet starts long before any material is cut. Measurements are taken, the intended use of the helmet is discussed, and a rider works with the maker to settle on a shell, lining and finish that suit them specifically, rather than picking from fixed stock sizes.

Once the shell is formed and cured, it moves through finishing: sanding, painting or leather trimming, and fitting the internal padding and retention system. Every stage is checked before the next begins, since a fault caught early is far cheaper to fix than one found at the end.