Understanding Duty Cycle Before You Buy An Inverter Welder

Getting the right disc for the material and finish you're after saves both abrasives and time, and it's worth checking your current selection against the job list with a supplier who stocks a full abrasives range, such as tec products ltd.

Switching speed, the time the filter takes to darken once it detects an arc, is worth checking against how you actually work rather than assuming faster is always better for every budget. For most general fabrication and repair work, a mid-range auto-darkening helmet with a sensible shade range covers the vast majority of jobs comfortably.

An auto-darkening welding helmet uses a liquid crystal filter that switches automatically from a light state to a dark shade the instant it detects an arc, then reverts once the arc is gone. This replaces the older habit of flipping a fixed-shade visor down and up by hand, which meant either welding blind for a split second or lifting the helmet to check your position before striking the arc. 3M Speedglas is one of the ranges we point people towards most often for this, alongside other options across different budgets.

A welding table is easy to overlook when planning a workshop, yet a poor one undermines accuracy on every job that touches it. If the surface isn't flat, nothing clamped or squared against it will be either, and small errors compound quickly on anything with multiple joints or angles.

Plasma cutting uses a jet of ionised gas, usually compressed air, forced through a nozzle at high speed and heated by an electric arc to a temperature hot enough to melt through electrically conductive metal. The molten material is then blown clear by the same jet, leaving a narrow, clean cut. Unlike oxy-fuel cutting, plasma works on any conductive metal, including stainless steel and aluminium, not just carbon steel. Hypertherm is the plasma cutting brand we get asked about most, and it's worth understanding the basics before comparing specific units.

Duty cycle is one of the most misunderstood figures on a welder's spec sheet, yet it tells you more about real-world usability than the headline amperage does. It's expressed as a percentage over a ten-minute period at a given output, so a machine rated at 30% duty cycle at its maximum amperage can run for three minutes out of every ten at that setting before it needs to rest and cool.