What Goes Into A Handcrafted Helmet Shell

Any impact, including a helmet dropped from a moderate height, can compress the inner liner in ways that are not visible from outside. A helmet is designed to absorb one significant impact by sacrificing that inner material, so a helmet involved in a crash should always be replaced, not inspected and reused.

Trying a helmet on in person, and wearing it for a few minutes rather than a few seconds, catches problems a size chart alone cannot. Padding also settles slightly with use, so a helmet that feels snug when new is usually the right call.

A handcrafted helmet shell starts with a base material, commonly fibreglass or a composite blend, layered and shaped by hand rather than produced purely by mould and machine. Each layer adds strength, and the shaping stage is where a lot of the time in production actually goes.

ECE 22.06 is the current European standard that motorcycle helmets are tested against, and it replaced the older ECE 22.05 standard with a wider and more demanding set of tests. Helmets are checked for impact absorption at multiple points on the shell, not just the crown, and the standard also tests rotational forces, which earlier standards largely ignored.

A made to order helmet starts long before any material is cut. Measurements are taken, the intended use of the helmet is discussed, and a rider works with the maker to settle on a shell, lining and finish that suit them specifically, rather than picking from fixed stock sizes.

To compare our full face and open face ranges side by side, see Heroine Racer.